Setting/Changing the IP Address using the LCD panel

  1. Use the down arrow to select the NETWORK menu. It's the top item in the menu. Press Enter to select.
  2. Press the down arrow until you see NET ADAPTERS. Depending on the unit and software version, this is around the 6th item. Press Enter to select.
  3. One of the network adapters' names is show; Intel, Attansic, Marvel, etc. †Press down to see the second name. Press Enter to select one of the adapters.
  4. Four items are in this new menu:
    1. IP Address†
      1. Press enter to change IP address.
      2. Use the up and down arrow keys to change each digit.†
    2. MSK (Subnet Mask)
      1. Press enter to change Subnet Mask value (for most networks, 255.255.255.000 will work, but ask your IT technician)
      2. Use the up and down arrow keys to change each digit.
    3. GW (Default Gateway)†
      1. Press enter to change the Gateway IP
      2. Use the up and down arrow keys to change each digit.
    4. Static/DHCP:†
      1. To set the IP as static, choose "SET STATIC" (which may appear as CHANGE STATIC if the IP was already static.
      2. To enable DHCP, press the down arrow to select SET DHCP
NOTE: When setting IP address, Subnet Mask, and Gateway, you must enter leading zeros, e.g. 10.4.70.123 is entered as 010.004.070.123. †The software will not allow any octet to be greater than 255, not even during the editing process.